RetroCompass
RetroCompass

Flydigi Vader 3 Pro — Firmware update

Quick answer

Steps

  1. 1Install Flydigi Space Station on your PC (or Flydigi Game Center on mobile).
  2. 2Connect the controller by USB-C (recommended) or the 2.4G dongle — not Bluetooth.
  3. 3Let the app detect the pad; if an update is offered, start it and keep the cable connected.
  4. 4Wait for completion; the app can also update the dongle and run stick calibration.

LED states

  • slow flash—Firmware updating — do not disconnect (indicative)
Last verified: 2026-06-20Source: shops.flydigi.com

Update firmware with Flydigi Space Station on PC (or Flydigi Game Center on mobile). Connect by USB-C or the 2.4G dongle so the app can see the controller — Bluetooth does not expose update/settings. The tool prompts when controller or dongle firmware is available; keep the cable attached until it finishes, then optionally run the guided stick calibration.

FAQ

Why can't the app find my controller?
Use USB-C or the 2.4G dongle; app access (settings, firmware, calibration) is unavailable over Bluetooth.
Does it update the dongle too?
Yes — Flydigi Space Station can update both the controller and the 2.4G dongle.

Same device — other tasks

Other devices — same task